ILVE 60 Series, Инструкция по эксплуатации, Страница: 5 / 21

Important:Use two wrenches to turn the fitting “G” to the required position. When the fitting is in the
desired position, firmly tighten nut “A” (Fig. 3).
WARNING - IMPORTANT:
after connecting the appliance to the gas supply (or to the liquid gas bottles) CHECK FOR LEAKS
at the union using a solution of soapy water(never use a naked flame).
CONVERSION TO A DIFFERENT TYPE OF GAS
Before converting the appliance for operation with a
different gas type, check which type of gas it is currently
set to operate with (adhesive label(Figure 1) on appliance).
Disconnect the electrical power supply to the appliance;
For the correct nozzle diameter, refer to the relative table in
this booklet.
Replacing the lower burner nozzle
1) Remove the burner cover plate (see REMOVAL OF
THE BURNER COVER PLATE page 42).
2) Remove the screw securing the oven burner and
withdraw the burner from the support together with the
heat sensor and the ignition spark plug. (Figure5)
3) Remove the nozzle using a 7 mm box wrench (Figure
6)
4) Screw the new nozzle in fully (diameter in hundredths
of millimetre stamped on the nozzle), taking care not to
cross the thread.
5) Replace the burner reversing the operations instep 2
above.
6) Replace the cover plate.
7) Adjusting the minimum flame(see instructions on page
16)
of 4 16