Page 6 of 7
6. CAM ADJUSTMENT
The cam of the cylinder can easily be adjusted to 12 symmetric positions around
the 360° (see right picture below), thus it is possible to change the default position
of the cam (which is not necessarily the DIN default position).
Due to that functionality, the cylinder is prepared for use in e.g. key switches,
where the default position is often at the 11 or 12 o’clock position.
To change the position please do the following steps:
A.
From the side of the cam there is a small hole visible.
B.
Stick carefully a needle (dimension:
Ø
2 mm with a sharp end) or similar inside the
hole to release the mechanism.
C.
After the release of the mechanism, it is possible to move the cam freely to the
necessary position.
D.
Take the needle out and check if the cam is locked in place.
A
B
C