version: july. 2018 - www.ilo-benelux.com
•
Under no circumstances turn the appliance on if it is on any surface.
•
The appliance must not be recessed in the ceiling. There must be enough space around the
top of the appliance to ensure adequate aeration. Use only the brackets supplied or the optional
ones to fix the appliance.
•
A minimum air gap of 30 cm should always be allowed between the top of the heater and a
ceiling or roof. The appliance should be 50 cm far from the walls (fig. 1 and 3).
•
A safety distance of not less than 100 cm should always be left in front of the Blacklight heaters
or too near.
•
This unit should be mounted at a minimum of 180 cm above ground level (fig. 1). If installed
in a toilet, the height should be 225 cm in zone 1 and zone 2; in zone 3 the minimum above ground
level is 180 cm, according with the rules of each Country.
•
The appliance must not be located neither directly below, nor in front of a socket-outlet.
•
The heater must be installed so as to prevent that the switches can be touched from those
who are in the shower.
•
Ensure that there is no possibility of inflammable material, combustible material or curtains
coming into contact with the heater, or lie near the heater.
•
The product is in class I and IP55, wich is the protection rate for the units to be used even
outdoor. For keeping the protection rate of the appliance, the connection of the appliance with the
power supply must be done by means of a minimum IP55 system, as per the standards HD 384
CENELEC for Europe, or international IEC 60346-7-708 1988.
3. FITTING
Before being used, the heater must be fixed to the wall or to the ceiling by means of
the provided supports, as described below. Before drilling the holes for the dowels,
be sure that the wall is solid and that you are far from water tubes or electrical wires.
Be sure that the heater is not facing the ceiling or inflammable materials.
1.
Drill four holes in the wall, following the dimensions in the table below:
2.
Fix the two supports (fig. 2 - pos. A) to the wall using dowels of appropriate size.
3.
Mount the two brackets (fig. 2 - pos. B) on the back of the appliance, inserting and sliding
them into the longitudinal slots.
