Water inlet hose
Do not use the water inlet hose of your old
machine. Use the new one supplied with
your machine instead. If you will connect a
new or long - unused water inlet hose to your
machine ,run water through it for a while
before making the connection. Connect the
water inlet hose directly to the water inlet
tap. The pressure supplied by the tap should
be at a minimum of 0.03 Mpa and and at a
maximum of 1 Mpa.If the water pressure is
above 1 Mpa,a pressure-relief valve should
be fitted inbetween.
After making connections, the tap should be turned on fully and
checked for water tightness.For the safety of machine, turn
off the water inlet tap after finishing each wash programme.
NOTE:
Aquastop water etc. spout is
used in some models. In case of using
Aquastop, a dangerous tension exists.
Do not cut the Aquastop water spout. Do
not let it get folded or twisted.
Water outlet hose
The water drain hose can be connected
either directly to the water drain hole or
to the sink outlet spigot. Using a special
bent pipe (if available), the water can be
drained directly into the sink via hooking
the bent pipe over the edge of the sink.
This connection should be between 50
and 110 cm from the floor plane.
Содержание IVFID10
