9850-000821-01. E&OE.
Status LED
Green LED flashes – device OK
Green LED flashes rapidly – DALI control
Data LED
Red LED flashes when messages sent on network
Alarm LED
Red LED solid on for local initiated alarm
Red LED flashes for network initiated alarm
Device Identification
Press and release switch.
Sending a message to identify the device on the network
(red Data LED flashes)
Device LEDs and Buttons
Typical Connection Diagram
SCMS0410
4 Channel x 10 Amp Switching Controller
230V
N
L
iLight Network
Termination
Connection
to the iLight
Network
Alarm
Input
DALI
Input
Device
Identification
Switch
10A Max
Channel
Indicator
Function
iCANnet Cable Colours
0V
Black
CAN L
Blue
Shield
Silver
CAN H
White
+VDC
Red
Maximum segment distance: 500m (1640 ft)
Devices per segment: 100 (without bridge or repeater)
Consult iLight for information on alternative cable types.
IMPORTANT NOTE: Connecting a mains potential cable to the
iCAN Network terminals is likley to damage the unit and other
devices connected, and invalidate warranty.
iCAN Network Connections
Network Power Requirements
Nominal operating voltage: 15V (12-18V)
Nominal operating current: 150mA
Network termination
The iCAN network follows a daisy chain topology that
requires termination on the devices located at either
end of the network.
The SCMS0410 unit is supplied with termination
disabled as standard. If it is connected as an end
device in the iCAN network, you need to move the
jumper to enable termination.
To enable SCMS0410 termination, move the jumper
outwards from the inner two pins to the outer two pins:
Termination OFF
Termination ON
iCAN
Device
iCAN
Device
SCMS0410
