______________________________________________________________________________________________________________________________________________________________
INC-MP Series & INS-MP1300 Megapixel IP Camera User Manual [16]
2.5
IP Speed Dome Installation
2.5.1
General Steps
Step 1: Open the bubble and remove the expandable poly ethylene and protective sticker from the dome drive. Refer to Figure 1.4.1.
Figure 1.4.1 Open bubble and remove the expandable poly ethylene and protective sticker from dome drive
Step 2: Configure the dome address, baud rate and other settings through DIP switch SW1 and SW2 located on the bottom board of the dome, as shown in
Figure 1.4.2. Usually you don’t need do this step because the dome address, baud rate and other settings of INC-MP1300 can be configured through
Expandable poly ethylene
Protective sticker
