Ilco Orion Rigel, Руководство по эксплуатации

Страница: 15 / 26

Operating manual - English RIGEL EU
13
6 REGULATION AND USE OF THE MACHINE
6.1
Checking and setting
The cutting tool on the RIGEL EU is the part used to cut the key blanks and should be periodically che-
cked and replaced, if necessary.
Every time the cutting tool is changed, and during periodical operational tests, check calibration.
6.2
Calibration
The RIGEL EU key-cuttung machine requires two types of calibration: axis and depth.
Axis calibration:
Axis calibration is regulation of the space between the stop and the cuts (fig. 7-A).
The axis setting for the RIGEL EU is fixed and is established on assembly in our workshops.
ATTENTION: Before carryng out this operation, adjust the cutting depth.
1) Remember to disconnect the machine from the mains.
2) Make sure the back of the gauges is lined up perfectly with the surface of the clamp and adjust the
interaxial distance using the positioners H.
3) Move the clamp carriage so that the cutter and the tracer fit in the V shaped slits in the gauges.(fig.
7-B).
4) The cutting interval of the machine is correct when the cutter and the tracer fit perfectly into the V
shaped slits in the gauges. Otherwise proceed as follows :
- Loosen the screw J1.
- Turn the knob K1 until the above mentioned occurs.
- Fasten the srew K1.
Fig. 7
B
K
J
K1
J1
A