Ilco Orion HALLEY BKA 2000, Руководство по эксплуатации, Страница: 14 / 26

HALLEY BKA 2000 Operating manual - English
14
6 REGULATION AND USE OF THE MACHINE
The cutting tool on the HALLEY BKA 2000 is used to cut the key blanks and must be periodically
checked and replaced. Periodically, and whenever the cutting tool is replaced, check the key-cutting
machine settings, to ensure perfect machine efficiency.
6.1 Setting
6.1.1 Adjusting the cutting depth
1) Insert the supplied gauges horizontally in the clamp housings (side 1) (fig.8).
2) move the carriage and make sure the tracer is well pressed against the gauge.
3) turn the cutter manually.
4) the cutting depth of the machine is correct when the cutter skims the gauge freely. Otherwise
proceed as follows:
- loosen the screw (J1) (fig.9).
- turn the screw (K1) (tighten it or loosen it until the cutter skims the gauge).
- fasten the screw (J1) (fig. 19, page 20).
Fig. 8
Fig. 9
K1
J1