IKUSI SPI-300, Основное руководство

Страница: 30 / 56

30
SPI-300 - Basic Guide
The screen closes using the OK command (key ). The Main Menu Screen
appears; through the Settings and Info menus you can know in detail all
current configuration and status data of the module.
If because of any circumstance the module has not been detected (it is
not powered, there is a failure in the connection to the SPI-300, ...) the
following error screen appears:
Close the screen by using the OK command. The Main Menu Screen
appears. In this case —module not detected— the unique menu is General,
which contains only the Detect and About Of commands. To perform again
a module detection operation, choose the Detect command.
2.3 - Parameter Setting
The parameter setting is carried out all the Settings menu long. This menu
presents, throughout several screens, the module's parameters grouped by
sections or categories.
Regardless the module type is, the setting process is as follows:
1. In the Settings menu, select the category of the parameters to be set
(Input, Output, V/A Selections, ...).
2. Enter the setting values.
3. Send the set values to the module by using the SEND command at the
left lower corner of the screen (key ).
4. Select, if necessary, other parameter category and repeat the previous
operations as far as all the parameter values have been set.
NOTE: Each time you use the SEND command, you send to the module
not only the values you have modified in the present screen, but also all
the values modified in the previous screens. Remember that the SEND
command is also available in the General menu.
Nevertheless the process described, some parameters are set in real time,
i.e. the values entered are transmitted instantaneously to the module (you
have not to use the SEND command). It occurs, for example, with the "Mo-
dulation Depth" and "Audio Level" parameters:
ATTENTION
No module has been
detected