Ikon EMPIRE 06, Руководство пользователя

Страница: 8 / 9

5. Care & Maintenance Gear
5.1 Bar
To open the quick release follow steps 1 through 8. To reassemble, follow the steps in
reverse and make sure to inspect all parts for damage and rinse the parts in fresh
clean water before reassembly.
Line management.
With the ends attached to a solid safe object and your de-power loop all the way
against the bar and sheeting system all the way out (powered up position), grab your
bar and pull back with a good amount of pressure. As you apply and release pressure,
all lines should rise and lower evenly and the bar should be perpendicular to the center
lines. If this is not correct you will need to do small adjustments to all lines to compen-
sate for this difference. It is important to weight each line individually and then do
adjustments. As you pull, each line will begin to lock the fibers into place and minimize
the elastic feel in the line. The more time you spend locking down the lines, the less
work and adjustments you will need to do later.
The goal for all the adjustments is to end up with all lines with the de-power loop and
sheeting system positioned all the way out (powered up position).
The first few times that you use your bar system, the lines and knots will settle in and
change length slightly. It is important to always check your lines after the first few ses-
sions, especially if your kite feels as if it is pulling to one side.
Now that you have your bar set up and ready, take your time and wrap your lines back
onto the bar. You will learn that taking your time wrapping your lines will result in less
twists in your lines when you lay them out the next time.
5.2 Kite
Dry your kite after use away from the sun and direct heat. Never Leave a wet kite in its
bag.
Store your kite in a dry place out of the sun.
Pre and post use check list.
• Bridle Lines: check no lines are damaged. If so, contact your dealer and change them.
• Sail: check there are no holes or tears in the sail. If your sail is torn, you can repair it
with the sticky cloth, provided in repair kit.
To repair the sail, make sure it is dry. Prepare two pieces of sticky cloth, one for each
side of the damaged area. The patch should cover the hole by at least 2cm all round.
Lay flat and stick on both sides. For bigger holes, please contact your sail repair.
4. KITE PRESENTATION
4.7 Pack
1. Secure your kite on the land with sand or snow
2. Wrap your lines back onto the bar in a figure 8
3. Open the velcro dump seam and remove any debris or snow that may have entered
the kite.
4. Fold your kite by bringing one wing tip to the center of the canopy and then fold again.
Repeat with the other wingtip.
5. If you leave your bar connected, put the bar next to the trailing edge and roll your kite
up folding 3 times with your bar inside. If you choose to disconnect your bar, stash your
bridle system in the velcro on the trailing edge.
6. Put the strap around the kite and put it in the bag.
14
15