8
-
Flat washers 6mm
12 pcs
-
Hex nuts M6-1
12 pcs
-
Lock nuts M8-1,25
2 pcs
-
Knobs M8-1,25 x 50
4 pcs
-
Knobs M8-1,25 x 20
2 pcs
-
Hex bolts M8-1,25 x 50
4 pcs
-
Hex nuts M8-1,25
8 pcs
-
Flat washers 8mm
4 pcs
If some parts are missing, please contact your dealer or the importer.
ASSEMBLY
This stand comes partially assembled. You need to install the wheels, the support rollers and your
miter saw.
To assemble the miter saw work stand (Fig. 3-5)
1.
Lay the stand upside down and unfold the top set of legs (Fig. 3). Make sure the locking pins
snap into place.
2.
Place a wheel bracket on either side of the wheel and thread an M8-1,25 x 45 hex bolt through
the assembly (Fig. 3), then secure it with a flat washer and a lock nut.
3.
Place the wheel brackets on either side of the stand leg and thread M6-1 x 45 hex bolts through
the wheel brackets (Fig. 3) and loosely secure them with flat washers and hex bolts.
4.
Unfold the remaining legs and install the support braces between the legs with M6-1 x 45 hex
bolts, flat washers and hex nuts. Note: This step is optional. Installing the support braces adds
stability but makes folding the stand more difficult.
5.
Place the stand upright, move the bottom of the wheels approximately 3 mm (1/8”) above the
floor and tighten the hex nuts.
6.
Place the roller crossbar between the extension arms and thread in the M8-1,25 x 5 knobs as
shown in Figure 4.
7.
Slide the roller assembly into the crossbar and secure it with an M8-1,25 x 20 knob (Fig. 4).
8.
Loosen the T-track lock knobs and adjust the T-tracks to the width of your miter saw, then slide
the heads of two M8-1,25 x 50 hex bolts into each T-track.
9.
Place the miter saw over the bolts and secure it with washers and hex nuts (Fig. 5).
ADJUSTMENTS
To adjust the stand (Fig. 6)
1.
Slide the extension arms out to their maximum reach and place a straight 2x4 across the miter
saw table and rollers.
2.
Loosen the crossbar knobs and rotate the roller assemblies until the rollers almost touch the 2x4
as shown in Figure 6. Then loosen the roller assembly lock knobs and slide the rollers up to
touch the 2x4.
STORAGE
To fold up the stand (Fig. 7)
1.
Remove the support braces, retract the extension arms and rotate the support rollers flat.
2.
Push in the locking pins as shown in Figure 7 and fold the legs up into the stand.
Содержание XW030
