TROUBLESHOOTING
24
Problem
Push buttons or
controls are sticky
or hard to operate
- Remove the camera and rinse the closed housing
in fresh water. Vigorously press each push button
in and out several times to release any trapped
saltwater or debris.
- Press a sticky push button all the way in and
place a small amount of lube on the small end of
the push button shaft at it’s base. Release and
depress the push button several times to distribute
the lube, Diagram I, page 19.
- If a larger gland style control is sticky, grab the
control knob, pull it out, and then push back in. If
still sticky, see the Control Maintenance section,
pages 19-22.
- Return housing to Ikelite for routine maintenance.
Image is over/
underexposed,
or a corner of the
image is dark
- Check that the built-in flash or external strobe is
firing when taking a picture. Camera flash should
be forced “on.”
- When using an external strobe, make sure it is
turned on, set properly, and its battery is charged.
- Check any corded connection points.
- Change camera shutter speed or aperture.
- Move closer to or further away from the subject.
- Adjust Exposure Compensation .
- Adjust Flash Exposure Compensation .
Solution
