13
The female bulkhead connector permits different Ikelite sync cords, EV Manual Controller or
a Fiber Optic Adapter to be connected to the strobe. These connectors relay signals from
the camera to the strobe to trigger the flash.
The removable waterproof bulkhead cap seals the bulkhead connector when nothing is
connected to the DS160. The strobe’s bulkhead connection must be sealed to remain
waterproof (page 14).
Caution:
•
Do not
leave the sync cord or sensor connected to the camera or strobe
for prolonged periods as electrolysis could occur and make removal of the
equipment impossible.
•
Do not
disconnect the sync cord or sensor from the housing or strobe when
underwater or when wet. These items are not waterproof when disconnected.
• Make sure there is no debris on the sync cord o-ring and the sync cord connector
is aligned properly when attaching to the strobe bulkhead (page 14).
CONNECTION TO STROBE
To connect either a sync cord or sensor to the DS160 Strobe, follow these instructions:
1. Turn the strobe to OFF and make sure all components are dry. Clean and
lightly lubricate the stem o-ring and the bulkhead connector threads.
Check the o-ring for nicks or cuts.
2. Note the positioning of the receptacles and pins on the end of the cord. Properly
align the end of the cord and insert it into the strobe bulkhead connector.
When using the 4103.51 cord, which connects an Ikelite housing to an Ikelite
Strobe, both cord ends are identical; either end can be connected to the
strobe.
3. The connector threads are very fine; do not cross thread. If it is difficult
to turn the knurled retaining ring on the cord or sensor, you are likely
cross-threading. This can make removal of the strobe or sensor impossible.
Hand-tighten the knurled retaining ring on the cord or sensor. Push the end of
the cord further into the bulkhead connector and continue to tighten the knurled
retaining ring.
Do not
use pliers or a tool when tightening. It could damage the
cord or strobe.
STROBE CONNECTION
