Bulkhead
Cap
Sync Cord O-ring
Housing or Strobe
Bulkhead
Ikelite TTL
Sync Cord
Sync Cord Pin
Knurled Nut
3. Line up the Sync Cord Pins with the corresponding Bulkhead
Receptacles. Gently insert Sync Cord ends into each Bulkhead. Either
Cord End may be attached to a component. DO NOT force this
installation.
If the Sync Cord does not seat properly inside the Bulkhead,
then the Pins and Receptacles are improperly aligned (repeat Step 3).
4. Tighten the Knurled Nuts snugly using your Index finger and thumb. DO
NOT use pliers or other tools to tighten the Knurled Nuts.
-
Always remove the Sync Cord from your Housing and Strobe when not
in use and replace the Bulkhead Caps.
Attach Ikelite Sync Cord to the Housing and Strobe -
cont.
Diagram E
16
