17
Troubleshooting
Push buttons or
controls are sticky
and hard to operate
- Remove the camera and rinse the closed housing
in freshwater. Vigorously press each push button
in and out several times to release any trapped
saltwater or debris.
- Press a sticky push button all the way in and
place a small amount of lubricant on the small
end of the push button shaft at it’s base. Release
and operate the push button several times to
distribute the lubricant.
- If a control is sticky, grab the control knob, pull it
out, and then push back in. If still sticky, see the
Control Maintenance section - pages 13-15.
- Return housing to Ikelite for routine maintenance.
Problem
Solution
Image is
over/underexposed,
or a corner of the
image is dark
- Check that the camera flash or strobe is firing
when taking a picture. Camera flash should be
forced “on.”
- Make sure the deflector is installed when you are
using an external strobe.
- Make sure the diffuser is installed when you are
NOT using an external strobe.
- When using an external strobe, make sure it is
turned on, set properly, and it’s battery is charged.
- Check any corded connection points.
- Change camera shutter speed or aperture.
- Move closer to or further away from the subject.
- Adjust Flash Exposure Compensation
- For extreme overexposure turn on the ND neutral
density filter if available on your camera.
