Ikelite 6147.89, Инструкция

Страница: 5 / 20

Closing the Housing
3. Guide the back onto the housing. The o ‐
ring should touch the housing all the
way around. There should be an even
gap all the way around between the
housing and the housing back.
4. Lift the lid snaps so they are
extended and place the lid snap
into the hook on the housing back.
5. To close the housing push
down on the lid snaps until
they snap into place . Lid
snaps on opposite sides of the
housing should be closed at the
same time. Be sure they are down
far enough to engage the lock.
Double check ‐ Once the housing is closed, check the o ‐ ring seal.
Check the gap between the housing back and the housing, it
should be even all the way around.
Look through the clear plastic back at the o ‐ ring. You should see a
darkened area where the o ‐ ring is compressed against the housing
back. If you do not see an even black compression seal all the way
around the back, open the lid snaps, reseat the housing back and close
the lid snaps. Visually check the seal again.
2. Check to see that there is an o ‐ ring
on the housing back and that it is
clean and in its proper location.
1. Place housing face down in your lap or
on flat surface.
5