2.
Apply a very thin, even layer of lubricant on all threads,
sealing surfaces, and the exposed portion of the plug
o-ring. Do not allow lubricant to get into the pins and
receptacles of the plug or bulkheads.
3.
Align plug and insert into the housing bulkhead. Each
male pin mates with a female receptacle. Failing to line up
the contacts properly before tightening may result in
damage to the converter plug and/or housing bulkhead.
4.
Hand-tighten the retaining ring.
5.
Attach a compatible sync cord to the converter using the
same method. Hold the converter while tightening the
sync cord retaining ring.
6.
Attach a compatible strobe(s) to the sync cord.
Setting Your Camera
Refer to your camera and housing instruction manuals for
recommendations on flash settings for external strobes. In
general:
•
Flash mode must be set to Fill flash or Rear Curtain
Sync. Do not use a red eye reduction mode.
•
DRO/Auto HDR must be turned off (default).
If you are having trouble getting your strobe(s) to fire or
expose properly we recommend restoring your camera
to factory default settings and making sure the hotshoe is
pushed all of the way forward.
Shooting with TTL Strobe Exposure
1.
Turn strobe on. When turned on the DL2 DS Link will be
in TTL mode. The LED indicator glows blue in TTL mode.
2.
Set the strobe to TTL.
3.
Exposure compensation may be added or subtracted
through the camera’s menus. Refer to your camera
instruction manual for more information.
»
It is only possible to toggle between TTL (blue LED) and
Manual (red LED) when a camera is connected.
»
An incorrectly mounted hotshoe may prevent toggling
between TTL and Manual.
Shooting with Manual Strobe Exposure
1.
Push the mode button on the side of the converter. The
LED indicator light will change from blue to red.
2.
Set the strobe to full or a fractional power setting.
3.
Adjust strobe power settings as necessary for each
photo.
4.
To revert to TTL operation push the mode button and set
your strobe to TTL.
Maintenance and Storage
Post-Dive
1.
Submerge the fully assembled system in clean, fresh
water after each use. Press the mode button several
times while submerged.
2.
Remove the system from the rinse tank and flush with
running fresh water.
3.
Dry the system with a clean, lint-free cloth.
4.
Separate the components and lubricate the threads and
o-ring(s) every 2-3 days during continuous use.
Travel and Storage
1.
Separate the converter from the sync cord and housing.
2.
Wipe off the threads of each bulkhead and retaining ring
using a clean, lint-free cloth.
3.
Lightly lubricate all o-rings, threads, and sealing surfaces.
4.
Attach the connector protector and waterproof bulkhead
cap to converter ends.
Limited Warranty
This Ikelite product is warranted against any manufacturing
defects for a period of one (1) year from the original date
of purchase. To obtain warranty service, the product must
be returned to Ikelite postage paid. Ikelite will, at its sole
discretion, repair or replace such products, and will return
to customer postage paid. All other claims of any nature are
not covered. Except as mentioned above, no other warranty
expressed or implied applies to this Ikelite product.
Ikelite Underwater Systems
50 W 33rd St
Indianapolis, IN 46208 USA
(317) 923-4523
[email protected]