Ikegami MKC-310HD, Руководство по эксплуатации

Страница: 46 / 54

46
5.5.1 Connection and setting
The 3D system of this machine is constructed one master machine, one slave machine and 3D -
adaptive monitor. Please connect each apparatus like a lower figure.
1.
Please connect SYNC connector of the CCU made a master and GENLOCK connector of the
CCU made a slave using a coaxial cable. And connect one between the RS-232C connector by
the RS-232C Crossing cable.
2.
Please connect the two CCU and the monitor.
※
Please connect the both CCU output signal to the 3D-compatible monitor
※
Whichever camera of the left or right is made the master, it is no problems.
※
Please check the Specification of the monitor for the connection of the output of the left and
right of the camera
3. Turn ON the main power switch.
（
It’s possible even from the left or right of the CCU.
）
4.
From MENU, please select by a cursor in the order of [Video Setting]
→
[3D Support]. Therefore,
please change the camera setting in ’Master’ in the case of Master, and in ’Slave’ in the case of
the Slave.
5.5.2 Linkage the operation panel and the menu
When the setting is finished, [White balance], [Auto shutter], [Auto sensitivity], [Auto Iris] and
[Set value of each volume] etc. are interlocked between the master and the slave, and setting that
was operated at the master is automatically is reflected by the slave.
Video Setting
Quit
Format 59.94Hz
SDI Setting 1080i
DVI Setting 1080p
Gamma ON
Master Gamma 0
Color Saturation ON
Color Saturation Gain 0
Genlock Mode
Auto
Genlock H Phase 0
Genlock V Phase 0
3D Support SLAVE