IKEA ASW0539-24020002A, Руководство пользователя

Страница: 10 / 12

10
Trouble shooting guide
NOTE!
Do always disconnect the cable from the wall socket before maintenance!
Symptom Check Try
The desk does not run
Is the main connected to the leg? Try to connect a lamp or similar
to the main supply to check that
the supply voltage is OK.
Are all plugs mounted
correctly between the legs and
power supply? See assembly
instruction.
Check all connections.
Are there visual damages on the
cables, controls or the legs?
Damaged parts must be
exchanged - Contact IKEA
Customer Service.
The desk stops and can only run
in the opposite direction.
Is the desk in fully extracted
position?
When the desk has reached its
upper position it can only run
downwards.
Is there much load on the desk
compared to when the desk
functioned normally?
Remove some of the load and
try again.
The desk will only run
downwards even though the
desk is not overloaded.
Perform Basic settings.
The desk does not run with full
stroke length upwards. Always
stops at the same position.
The system has a new endstop
outwards. Perform Basic settings
to remove this stop.
The desk does only run a little
upwards and stops.
Has the correct screws been
used when mounting the frame
to the legs?
Check if the screw used have
the correct length (assembly
instruction). If the screw is too
long it can damage the leg.
Is all connections correct? Check all connections.
Is the desk loaded much? Reduce weight load and try
again. A Basic setting might be
needed before the desk will drive
upwards.
Basic Setting:
Push the controller downwards. Run the table to the bottom position and keep the pressure on the
controller for min. 6 seconds after both legs have reached bottom position.
At certain errors types this must be done twice in succession. Now the desk is in initial position.