IKEA 504.756.18, Руководство пользователя

Страница: 25 / 36

Problem and alarm code Possible cause and solution
The appliance does not fill
with water.
The display shows i10 or i11.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authori‐
ty.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not drain
the water.
The display shows i20.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows i30.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in the
user manual.
Malfunction of the water lev‐
el detection sensor.
The display shows i41 - i44.
• Make sure that the filters are clean.
• Switch the appliance off and on.
Malfunction of the wash
pump or the drain pump.
The display shows i51 - i59 or
i5A - i5F.
• Switch the appliance off and on.
The temperature of the wa‐
ter inside the appliance is too
high or malfunction of the
temperature sensor occur‐
red.
The display shows i61 or i69.
• Make sure that the temperature of the inlet water does
not exceed 60°C.
• Switch the appliance off and on.
Technical malfunction of the
appliance.
The display shows iC0 or iC3.
• Switch the appliance off and on.
The level of water inside the
appliance is too high.
The display shows iF1.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation instruc‐
tions.
The appliance stops and
starts more times during op‐
eration.
• It is normal. It provides optimal cleaning results and ener‐
gy savings.
ENGLISH 25