Getting to know your LIGHTSTAR Light
The Lightstar LSW-003 (1000 watt) LSW-004 (2000 watt) fixtures are intended for professional applications, and are only to be
operated by qualified persons. Please read the following operating instructions very carefully before using these fixtures. They
contain important information on the operation of Lightstar lighting. For your own safety, please follow all safety instructions and
warnings. Please also follow the operating instructions of the lamp manufacturers. Please keep these operating instructions
for you and subsequent users to reference in the future.
CAUTION:
These fixtures use high voltage, before replacing the lamp; disconnect the fixture from its power
supply. Warning! Lamp may be hot! Allow the lamp to cool down sufficiently before replacing it. Do not
switch on the Fixture without a lamp inserted. Do not switch on the fixture without a Fresnel lens, safety
mesh and reflector in place. Warning! The housing of the fixture can achieve very high temperatures. Do not
cover any ventilation slots. Always keep the mains cables away from the hot housing. A risk of overheating
or fire can occur if misused. Do not overtax the fixture cables for transport or suspension of fixture. Always
remove the lamp from the fixture for transport. Do not operate the fixture if it shows any visible damage.
Mounting the Fixture
Loosen the thumb screw on the yoke. Bring the fixture to the desired position. Tighten thumb screws until it locks in place.
Check to ensure the fixture is securely fastened.
If the fixture is being used in a hanging position, be sure to secure the fixture with a safety cable from the mounting pipe or truss.
Accessories, not secured with a safety rope must be secured with a safety cable as well. The carrying capacity of the safety
rope must be rated at a minimum of 10 times the weight of the fixture system including accessories. Stands must be set up in
a stable position and capable of carrying the weight of the fixture including accessories and cables.
Getting the Fixture Operational
Inserting the Lamp
Before replacing the lamp the fixture must be disconnected from the power supply. Before inserting, visually check the lamp for
functionality. Damaged lamps must not be operated. Ensure the lamp is firmly fastened in its socket and the lamp holder before
every use. Warning: The voltage rating of the lamp must match the fixtures voltage. Connect the lamp head connector to the
power source, and put the cable switch to the ON position.
For the LSW-003 (1000 watt) and LSW-004 (2000 watt) fixtures open the latch on the front of the fixture. Turn the focus knob
to move the lamp holder to the spot position (maximum distance between lamp and Fresnel lens. The front housing will swing
forward allowing you access to the lamp holder. Pull out the lamp carefully from the lamp holder. WARNING! The contact pins
of the lamps have different diameters and have to be matched to the right contact point of the lamp holder. Insert the lamp
carefully as far as possible into the lamp holder.
Inserting Accessories
Inserting and exchanging accessories must be carried out from a stable position. On the LSW-003 and LSW-004 press the pin
on the side of the holding bracket to release the spring. Insert accessories, e.g. barn door, or scrim into the bracket. Make sure
the accessories are securely locked.
WARNING! Do NOT operate the fixture with closed barn doors! The risk of overheating can occur.