LNU sensor : Installation & programming
Installation Guide
K0J00016-EN-A02
IJINUS – 25 ZA de Kervidanou 3 – 29300 MELLAC – FRANCE
-
www.ijinus.com
-
18
This operation validates the input of these data in the table by displaying the number of lines, then can activate,
depending on calculation needs, flow calculation and log and eventually to control a water sampler.
Once the programming is done,
a resume summarized your different choices
Finishing of the programming: you must validate with the “Program the device” button to send the configuration in
the sensor memory:
After the saving operation is done, please check that you have at the top right corner the two green signs showing that
the sensor is working, recording and also sending data. You can stop them both by pressing the red Stop icon, if needed.
