ENGLISH
BEFORE YOU OPERATE THE MONITOR 11
CONNECTING YOUR MONITOR
Ensure that both the computer and the monitor are switched off .
Connect the computer to the monitor with the signal cable.
Connect the Light Sensor Cable to the monitor.
Connect the Power Cable to the monitor fi rst and then to the power supply.
Turn on your monitor (Main Power Switch and Power Switch) and computer.
The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama offi ce.
For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama offi ce for a suitable adaptor.
Make sure you tighten the fi nger screws at each end of the Signal Cable.
The Class I pluggable equipment Type A must be connected to protective earth.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
[Example of Connection]
<Back>
NOTE
Computer
AV Equipment
VGA Cable (Not Included)*
HDMI Cable (Accessory)
Power Cable (Accessory)
DisplayPort Cable (Not Included)
DVI-D Cable (Not Included)*
RS-232C Cable (Accessory)
Audio Cable (Not Included)
Light Sensor Cable (Accessory)
* Cable is not supplied with the monitor. If you use low quality cable, it may cause a result of electro-
magnetic interference. Please contact the iiyama Support Centre in your country if you wish to
connect the monitor via the VGA or DVI input.
