Iiyama ProLite LH4664S, Руководство пользователя

Страница: 20 / 43

ENGLISH
16 BEFORE YOU OPERATE THE MONITOR
CONNECTING YOUR MONITOR
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.*
Connect the Power Cable to the monitor fi rst and then to the power supply.
Turn on your monitor (Main Power Switch and Power Switch) and computer.

The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama offi ce.

For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama offi ce for a suitable adaptor.

Make sure you tighten the fi nger screws at each end of the Signal Cable.

Don’t connect the RS-232C cable and the USB cable to the computer at the same time.
And cannot use those at the same time.*

When USB cable connected than wait for 5 seconds and the touch function is ready to
go. It can be activated by pen, fi nger or any other pointer.*
[Example of Connection]
<Back>
NOTE
* Available for ProLite TH4664MIS only.
Computer
AV Equipment
VGA(D-sub)
Signal Cable
(Accessory)
DVI-D Cable
(Accessory)
HDMI Cable
(Not Included)
Power Cable
(Accessory)
USB Cable(Accessory) *
Audio Cable (Not Included)
DisplayPort
Cable
(Not Included)