2
22
Advanced Setup Method
Advanced Setup Method
2
se
ct
io
n
2
1
3
4
5
6
7
Passwords can contain from to2 alphanumeric characters which
are case sensitive.
Note:
If your password is lost, or you cannot gain access to the
user interface, press the reset button (colored blue) on the rear
panel (holding it down for at least 20 seconds) to restore the factory
defaults. (By default the password is “admin”)
Enter a maximum Idle Time Out (in minutes) to define a maximum
period of time an inactive login session will be maintained. If the
connection is inactive for longer than the maximum idle time, it will be
logged out, and you will have to login to the web management system
again. (Default: 0 minutes)
Remote Management
By default, management access is only available to users on your
local network. However, you can also manage the VoIP Router from
outside your network via remote management by checking the
Enabled check box. You can set a HOST ADDRESS, which will only
allow that computer to use remote management. The port field should
be left as the default setting of 8080 unless you need to change it.
After any changes are made you must click on “Save Settings” to
apply them.
Note:
If you check “Enabled” and specify an IP address of 0.0.0.0,
any host can manage the VoIP Router.
For remote management via a WAN IP address you need to
connect using port 8080. Simply enter WAN IP address followed
by :8080 in the address field of your web browser, for example,
http://22.20.68.20:8080. This applies unless you change the port
setting, in which case you need to substitute the 8080 for whatever
port you have assigned.
