Configuration
Draco vario
DisplayPort
1.1
42
7.5 Configuration File
The extender module contains a configuration file (
Config.txt
) to set specific parameters and to read out device
and video information. The configuration file is located on the flash drive of the extender module. The flash drive can
be opened by a Mini-USB connection to a computer. The configuration file can be edited with all common text
editors.
NOTICE
If the start command
#CFG
is missing or is written to the wrong place, or if parameters are not separated in extra
lines, the parameterization will fail. For a successful parameterization, the following sequence must be strictly
observed.
To enter or change a parameter of an extender module, proceed as follows:
1. Connect the extender module to any source using a Mini-USB cable.
The extender module opens a flash drive containing the
Config.txt
file.
2. Open the
Config.txt
file in a text editor.
3. Ensure that
#CFG
is written in the first line of the file.
4. Add a line break directly behind
#CFG
.
5. Add the parameter/s in capitals in the line below
#CFG
(one line per parameter).
6. Add a line break directly behind each parameter.
7. Delete everything that follows the entered parameter/s, including blanks and blank lines.
8. Save the
Config.txt
file.
9. Manually power off the extender module.
10. Power on the extender module to restart the extender module.
The extender module starts automatically, and the extender module parameters will be rewritten in the
Config.txt
file.
Example
Fig. 20
Example Config.txt with parameters
