1
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
KIT CONTENTS
1 ea. UZY6 Blower Assembly
1 ea. Mill-pack
1 ea. Instruction Sheet
TOOLS NEEDED
Robertson (square) or Phillips (star) screwdriver
INSTALLATION INSTRUCTIONS FOR INSTALLING UZY6 REPLACEMENT BLOWER KIT
FOR USE WITh WOOD-BURNING FIREPLACES LISTED IN TABLE 1
WARNING
The blower must be plugged directly into a properly
grounded three-prong receptacle, 120 VAC, 60 hz,
single phase. Do not cut or remove the grounding prong
from this plug.
Installation must be in accordance with National Elec-
trical Code, ANSI/NFPA 70 - latest edition. In Canada,
the current CSA C22.1 Canadian Electrical Code - latest
edition.
UZY6 REPLACEMENT BLOWER KIT
Cat. No.
Model
Where Used
PR-UZY6
UZY6
Ladera™, BIS
®
Nova, Brentwood™ LV,
BIS Ultima CF
Table 1
Figure 1
GENERAL INFORMATION
The UZY6 blower kit is a replacement part kit for the standard air-circulating
blower provided with the fireplace.
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact your local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS AND PRECAUTIONS IN ThE INSTALLATION AND
OPERATION MANUAL PROVIDED WITh ThE APPLIANCE APPLY TO
ThESE INSTRUCTIONS.
ShUT DOWN ThE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
UZY6 BLOWER KIT
P/N 506019-80
Rev. B, 07/2013
HEARTH PRODUCTS
KITS AND ACCESSORIES
INSTALLATION INSTRUCTIONS
Step 1.
Remove the andirons, using a square or phillips screwdriver.
Then remove front and bottom refractories.
Step 2.
Unscrew the access plate located in the firebox floor (12 screws).
Remove the access plate and the high heat cement used to seal
it.
Step 3.
Unplug the blower from the electric receptacle located on the
right side of the fireplace.
Step 4.
Unscrew the blower using a Robertson (square) or Phillips
(star) screwdriver. The location of the two screws depends on
the version of the blower installed (see Figure 1). They can be
at each end of the support bracket close to the floor (Version B)
or on top of the support bracket near the left side (Version A).
See figure 1.
Step 5.
Take the blower out of the fireplace through the access opening.
Version A
Unscrew these two screws
Version B
Or these screws
to remove the blower
F161 REV. 2 07/2013
