NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
2
ALLUMEDLX60TEN-B and DRL6060TEN-B model only
, disconnect
blower assembly power cord from the fireplace control module
harness. Discard blower assembly and blower harness as blowers
are not compatible on a see-thru application.
Preparing Fireplace for See-Thru Application
1. Install rear standoff assembly, as shown in
Figure 2
, using eight
(8) of the #10 hex head screws.
2. Install the standoff heatshield, using three (3) #10 hex head screws
(two in the lower front, and one going upward into the standoff
assembly). See
Figure 2
.
3. Remove the rear heatshield assembly by removing the 12 hex head
screws fastening it to the back of the fireplace. This assembly will
not be reused and can be discarded
(see
Figure 2
)
.
Figure 2
Figure 3
Figure 4
Rear Standoff
Assembly
Rear Heatshield
Assembly
Standoff
Heatshield
False Door
4. Remove the ten (10) hex screws fastening the false door to the
fireplace. Lift upward and outward to remove false door. Remove
any gasket material that may have been left behind on the firebox
door mating surface. This part will not be reused and can be
discarded
(see
Figure 3
).
5. Place the bottom edge of the door assembly into the door channel
on the firebox. The tabs on the bottom of the door on each side
will fall into corresponding slots on the door channel of the firebox
(see
Figure 4
)
.
6. While holding the door closed, place one of the sight obstructors
against the door as shown. With both the door and sight obstructor
in place, fasten them to the firebox together using five (5) #10
hex head screws
(see
Figure 4
)
.
Door Assembly
Bottom Door Edge,
Tab and Channel
Sight
Obstructor
7. Attach the remaining sight obstructor to the upper heatshield as
shown using five (5) #10 hex head screws
(see
Figure 5
)
.
