NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
5
Install rear fl oor section (from required fl oor kit)
1.
Place lower back edge of rear fl oor section on rear ledge of
fi replace, behind the tabs
(
Figure 10
)
.
2.
Align outermost front hole on either side of rear fl oor
section with hole in center lower tab in each side panel. Pull
rear fl oor section forward until it butts against the burner,
and secure using two (2) #10-16 x 3/8 hex-head sheet
metal screws provided with the fl oor kit (one screw per
side).
Rear
Floor
Section
Rear
Ledge
Tab
~
Side Panel
(Center Lower Tab)
Figure 10 - Installing the rear fl oor section
Install front fl oor section (from required fl oor kit)
1.
Engage the lower front lip of the front fl oor section under
the locking clips attached to the fi replace front ledge, and
then slide it back
(
Figure 11
).
2.
Align the notches in the back edge of the front fl oor section over
the holes in the rear fl oor section. Push the front fl oor section
backward until it butts against the burner, and screw the front
fl oor section as shown in
Figure 11
.
Figure 11 - Installing the front fl oor section
Install media (from optional media kit)
1.
If installing a fl oor kit that requires media, place an even
layer of media in the recessed area around the burner (see
bold outlined area in
Figure 12
; also refer to
Figure 1
).
Figure 12 - Placement of media
WARNING
• Handle media only when cool. Turn OFF all electricity
to the appliance before installing media. Media gets
very HOT during fi replace use and will remain hot up
to ONE HOUR after the gas supply is turned off.
• Any attempt to use media not specifi ed for your fi replace
confi guration will result in incomplete combustion,
sooting, and poor fl ame quality, and will void the
warranty.
• Do NOT mound up media, especially on the burner.
• If using multiple colors of media, NEVER use more
than fi ve (5) pounds total (approximately) at one time.
• Do NOT allow media to get into the pilot hole.
Locking Clip
Front
Ledge
Notch
Rear
Floor
Section
Front
Floor
Section
Lip
