IHP.US.com
506019-40 A
2
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
2
Figure 3
Step 2. Locate two screws (one left and one right) in the fireplace
support structure (see Figure 3 ) and (using a 5/16” nut driver) remove
them. Position the exhaust ramp and install it by replacing the screws
that were removed.
Step 3. Locate and loosen (using a Phillips screwdriver) two screws
attaching the base adjustment bracket to the façade base. Hold the façade
base in front of the fireplace and engage the base tabs in the slots on the
fireplace (see Figure 4 ). Press the façade base back against the wall/fin-
ish materials as far as it will go and tighten the screws (see Figure 5 ).
IMPORTANT: Ensure that the façade base upper flange is above the
exhaust ramp. The exhaust ramp must be unobstructed and properly
engaged with the façade base to allow the exhaust to escape from the
fireplace (See Figure 6 ).
Figure 4
Figure 5
Attaching The Exhaust Ramp
Fireplace Slots
Tighten Screws On Base Adjustment Bracket
Figure 2
INSTALLATION INSTRUCTIONS
Step . Install the exhaust ramp in the opening above the fire place front
glass enclosure panel (see Figure 2 ).
Exhaust Ramp
Engage Base Tab
Base Adjustment Bracket
Frame Base
Facade Base
Fireplace
Exhaust
Ramp
Facade Base
Upper Flange
Side View
Figure 6
f i r e - p a r t s . c o m
