IHP (C)(GC)IR10NTA/NMA series, Руководство пользователя

Страница: 16 / 28

15
INSTALLATION
Attaching to Wall Anchor Method
For attaching mounting bracket to hollow walls (wall areas
between studs) or solid walls (concrete or masonry):
1. Drill holes at marked locations using 5/16-inch drill bit.
For solid walls (concrete or masonry), drill at least
1 inch deep.
2. Fold wall anchor as shown in (See Fig. 17).
3. Insert wall anchor (wings first) into hole. Tap anchor
flush to wall.
4. For thin walls (1/2 inch or less), insert white key into wall
anchor. Push white key to “pop” open anchor wings
(See Fig. 18).
IMPORTANT : Do not hammer anchor key! For thick
walls (over 1/2 inch thick) or solid walls, do not pop
open wings.
5. Place mounting bracket onto wall. Line up last hole on
each end of bracket with wall anchors.
6. Insert mounting screws through bracket and into wall
anchors.
7. Tighten screws until mounting bracket is firmly fastened
to wall.
8. Check that the bracket is secure before mounting
heater!
Attaching Wall Hanging Spacers to Heater
WARNING: Failure to properly install the wall hanging
spacers may result in property damage, personal injury
or even death.
1. Locate spacer mounting holes on the lower right/left
sections of the heater back panel.
2. Secure (2) Wall Hanging Spacers to heater back panel
using (2) Spacer Screws ST4.8*45 (See Fig. 19a).
Placing Heater On Mounting Bracket
1. Locate two horizontal slots on back panel of heater.
2. Place heater onto mounting bracket. Slide horizontal
slots onto stand-out tabs on mounting bracket. Be sure
spacers rest evenly against wall (See Fig. 19b).
Fig. 17 - Folding Anchor
Fig. 18 - Popping Open Anchor
Wing For Thin Walls
Fig. 19b - Mounting Heater
Onto Mounting Bracket
Horizontal Slots
Fig. 19a - Attaching Wall
Hanging Spacers to Heater
Spacers