IHOS NAXOS Series, Руководство пользователя

Страница: 9 / 16

1. Before connecting the power or signal cables, mount or position your NAXOSLoudspeaker where
you intend to use or try it, do not carry it with any cables connected.
2. Set the MIC/LINE and BT/AUX input levels to minimum, the Master EQ controls to their mid
positions, then connect the AC power and switch on the Loudspeaker.
two second delay between switch-on and any indication of power.
NAXOS
3. Connect your source or host device as follows:-
1. Note: The MIC/LINE inputs of your NAXOS Loudspeaker will be set to LINE mode from new and will
need to be switched to MIC mode.
2. Using a small screwdriver or similar implement, with care, switch your chosen MIC/LINE1 or
the input to MIC mode.
3. Connect your microphone or wireless microphone receiver via the chosen TRS jack or XLR
input of your NAXOS Loudspeaker.
4. Ensure that your wired microphone or wireless microphone system is switched on and that its
volume control is not set to minimum.
5. Speak into the microphone while slowly increasing the level control of the corresponding MIC/
LINE NAXOS input until you hear your voice in the speaker.
6. Always keep the microphone away from the speaker when using increased levels to avoid
acoustic feedback squealing/howling.
1. The wired inputs of your NAXOS Loudspeaker will be set to LINE mode from new, therefore it should
be ready for connection to a sound mixer. But this can be confirmed as described in the previous
paragraph if required.
2. Connect your sound mixer to the Loudspeaker via its TRS jack or XLR inputs. Note: for stereo
reproduction from a stereo source, you will require two matching BX Loudspeakers connected as
one for each of the Left and Right stereo channels.
3. Ensure that your chosen sound mixer is outputting a signal and that its volume is not set to
minimum.