6900 the watch receiver
Number register
1) Standby mode, press and hold key [FUN], until
‘F01’ shows on the screen.
2) Press and hold key [FUN] until the number
‘001’or ‘001-01’appears. There are two
kinds of number format. (Refer to step 9 to change the format)
3) Press [ENT] to change the flashing number, press [FUN] to move the cursor (each
position can set from 0-9 and A-Z).
4) Press and hold key [ENT] to delete the current number. (If this number is registered
before, the number is flashing that means deletion is successful. Otherwise, the
number will not flash that mean this number is not registered before.)
5) After getting the number you want, press down the call pager, the receiver vibrated
with the registered number flashing on the screen, the registration is finished.
6) To register more than one pager, please repeat the 5) after the first one finished.
7) After finishing the all numbers, press and hold key [FUN] till
‘F01’ shows on screen.
8) Press and hold [ENT] till back to standby mode. The register is done.
※
Special instructions:
Can register 500 numbers at most
During the registration, if the number does not flash or vibrate that means the number is
not registered successfully. You can judge the problems according to the digits behind the
calling number:
1-Means this number is not registered, but this pager has been registered to another
number.
2-Means this number has been registered by other pager before.
3-Means the pager and number are both registered successfully.
4-Means the number capacity has got the limitation of 500.
No digit means the receiver did not get the calling signal.
4. Delete the calling number
The calling number shows on the screen (The cycle interval time is two seconds, the
maximum is ten numbers.)
1) Press and hold [FUN] to delete all called numbers to back to standby mode. This way
can delete all called numbers with only one key.
2) Short press [ENT] to delete the current calling number. This way can delete the current
calling numbers with only one key.
5. Vibration time setting
1) Standby mode, press and hold key [FUN] 3 seconds till
‘F01’ appears.
2) Press key [ENT] to choose
‘F02’.
3) Press and hold [FUN] till a number
‘01-15’ appears. Press key [ENT] to choose the
number you want. (
‘01-15’ means 1-15 seconds of vibration prompt time, one digit
means one second.)
4) Press and hold [FUN] till
‘F02’ appears again.
5) Press and hold [ENT] till back to standby mode, vibration time setting is done.
