background image

FCC INFORMATION

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. 
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may 
cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s 

authority to operate the equipment.

• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, 
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference 
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with minimum distance 20cm 

(8in)

 between the radiator & your body.

ISED INFORMATION

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s 
licence-exempt RSS(s). Operation is subject to the following two conditions: 
(1)  This device may not cause interference.
(2)  This device must accept any interference, including interference that may cause undesired operation of the device.
The device 

complies

 with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance.

This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
Any 

changes

 or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the 

equipment.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement 
économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1)  L’appareil ne doit pas produire de brouillage; 
(2)  L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
L'appareil est conforme aux exigences d'exposition RF ISEDC, les utilisateurs peuvent obtenir des informations canadiennes sur l'exposition 
aux RF et la conformité.
Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
Tout changement ou modification non expressément approuvé par la partie responsable de la conformité peut annuler l'autorité de 
l'utilisateur à utiliser l'équipement.

MAINTENANCE

• Always unplug the power adapter before carrying out any cleaning or maintenance.
• Cleaning and maintenance time of filter for reference: About once a month. The filter surface should only be cleaned with 

a brush, dry cloth or vacuum. Do not use water or detergent to clean the filter. The material of filter can easily be damaged 
and deformed during cleaning. Do not press or pull hard. Replace with a new 

filter

 if it appears damaged. 

• Filter replacement time for reference: About every 6-8 months. This will depend on the area of use, such 

as heavy pollution 

and smoking areas, which can shorten the filter’s life.

• The exterior housing of the unit can be cleaned using a slightly moist, not wet, cloth or sponge. Wipe the outside surface 

and the air inlet and outlet.  Please do not use chemical 

cleaners

 to clean the surface.

• Before plugging the power adapter back into an electrical outlet, allow the unit to dry completely.

CAN ICES-3(B) / NMB-3(B)

Содержание iWAP260









Отзывы: