3
Getting Started
Thank you for purchasing the iHome iP41 Alarm Clock for your iPhone/iPod. Designed specifically to work with
your iPhone or iPod Touch, this system provides high quality audio performance and lets you enjoy videos in
horizontal view.
Please read this instruction carefully before the appliance is operated and keep it for future reference.
Install iPhone/iPod Insert & Cradle
Your iP41 comes with two cradles for support when viewing videos in horizontal mode and three inserts
to ensure your iPhone/iPod fits properly in the dock.
To place a cradle
:
1. Select the small iPhone /iPod touch cradle for use with those models or the taller nano cradle for use with
nano 4G.
2. Press cradle into the vertical cradle slot on the unit (near the dock).
To place an insert
:
1. Select the insert for your iPhone/iPod. (see table on page 1)
2. Gently press the iPhone/iPod insert into the dock.
3. Carefully place your iPhone/iPod into the dock. The iPhone/iPod must not be in a case or “skin”.
Install AC Adaptor
Connect the AC adaptor cable plug into the jack on the back of the system, then plug the AC adaptor into the
wall outlet.
Install/Replace backup Battery
The iP41 uses a CR2032 battery for backup battery system to provide continuous alarm operation and clock
settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the
AC cord is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time
settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings.
1. Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery
replacement.
2. Open backup battery compartment door located on the back of the unit.
3. Insert a new CR2032 battery, checking that the polarity (+ and – ends of the battery) matches the drawing
near the battery compartment. Close the compartment door.
WARNING
:
Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed
to water, fire, or high temperatures. Do not place loose batteries in a pocket, purse, or other container
containing metal objects, mix with used or other battery types, or store with hazardous or combustible
materials. Store in cool, dry, ventilated area. Follow applicable laws and regulations for transport and
disposal.
Using Sleep Mode
Press the Sleep Button while your iPhone/iPod is playing to enter sleep mode and continue to press to step
through the available sleep times: 90, 60, 30 and 15 (OFF will cancel sleep mode). A sleep icon will appear on
the display. The iP41 will play for the number of minutes set, growing gradually softer until shutting off the unit
and the iPhone/iPod at the set time. Press or
Button
to set sleep volume. Note that sleep volume is
separate from normal/alarm volume setting.
Using Dimmer
Press the
Snooze/Dimmer Button
during normal operation to adjust the brightness of the LCD display to
high, medium, low or off.
Using the EXB effect
Slide the
EXB Switch
at the back of the unit to the ON position to enable the EXB sound enhancement
circuitry, designed to provide bigger bass sound. Slide to OFF to cancel the effect.
6
Using the iP41
April 03, 2009
