Model iM71
Color-Changing
Portable Rechargeable
Audio Aux-in Speaker
Questions? Visit www.ihome.com
CHARGE
BEFORE
USE
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This Device complies with RSS-210 of the IC Rules; Operation is subject to the following two conditions:
(1) This device may not cause interference and
(2) This device must accept any interference received, including interference that may cause undesired operation
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B)/NMB-3(B)
IC Statement
This device complies with Industry Canada RSS-210. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio RSS-210.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance
with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la
conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition
et la conformité de rf.
IMPORTANT
Read before proceeding
If you have any question regarding the operation or use of this product, please visit
www.ihome.com
to view answers to frequently asked questions.
To learn more about this and other iHome products, please visit us online at
www.ihome.com
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI),
warrants this product to be free from defects in workmanship and materials, under
normal use and conditions, for a period of one (1) year from the date of original
purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it
to the store where it was originally purchased. Should this fail to resolve the matter
and service still be required by reason of any defect or malfunction during the warranty
period, SDI will repair or, at its discretion, replace this product without charge. This
decision is subject to verification of the defect or malfunction upon delivery of this
product to the Factory Service Center authorized by SDI Customer Service. The
product must include proof of purchase, including date of purchase. An out-of-warranty
fee for service will be charged for units that are received without proof of purchase.
Before returning this product for service, please first replace the batteries (if applicable)
with fresh ones, as exhausted or defective batteries are the most common cause of
problems encountered.
If service is still required:
1. Call SDI Customer Service at 1-800-288-2792 for Return Authorization and for
the address of the Factory Service Center.
2 Remove the batteries (if applicable) and pack the unit in a well padded, heavy
corrugated box. SDI is not responsible for damage that occurs during shipping to
the Factory Service Center.
3. Enclose a photocopy of your sales receipt, credit card statement, or other proof
of the date of purchase, if within the warranty period. Also include your name and
address information, a brief description for why the unit is being returned, and the
return authorization number. No unit can be processed without a return authorization
number.
4. Write the return authorization number on the side of the shipping package and
send the unit prepaid and insured to the Factory Service Center address authorized
by SDI Customer Service.
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it
was designed. It does not cover (i) products which have been damaged by negligence
or willful actions, misuse or accident, or which have been modified or repaired by
unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive
heat; (iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv)
the cost of shipping this product to the Factory Service Center and its return to the
owner.
This warranty is valid only in the United States of America and does not extend to
owners of the product other than to the original purchaser. In no event will SDI or any
of its affiliates, contractors, resellers, their officers, directors, shareholders, members
or agents be liable to you or any third party for any consequential or incidental
damages, any lost profits, actual, exemplary or punitive damages. (Some states do
not allow limitations on implied warranties or exclusion of consequential damages,
so these restrictions may not apply to you.) This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
Your acknowledgement and agreement to fully and completely abide by the above
mentioned disclaimer of warranty is contractually binding to you upon your transfer
of currency (money order, cashier's check, or credit card) for purchase of your SDI
product.
© 2014 SDI Technologies, Inc. All rights reserved
Questions? Visit www.ihome.com
or call 1-800-288-2792 Toll Free
Limited 1 Year Warranty Information
Printed in China
iM71-140321-A
iM71 IB English Front
324Wmm x 208Hmm
Print in 1C+1C Black color
Mar 21, 2014
A Consumer Guide to Product Safety
When used in the directed manner, this unit has been designed and manufactured
to ensure your personal safety. However, improper use can result in potential electrical
shock or fire hazards. Please read all safety and operating instructions carefully before
installation and use, and keep these instructions handy for future reference. Take
special note of all warnings listed in these instructions and on the unit.
1.
Water and Moisture
– The unit should not be used near water. For example:
near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet
basement.
2.
Ventilation
– The unit should be situated so that its location or position does
not interfere with its proper ventilation. For example, it should not be situated
on a bed, sofa, rug or similar surface that may block ventilation openings. Also,
it should not be placed in a built-in installation, such as a bookcase or cabinet,
which may impede the flow of air through the ventilation openings.
3.
Heat
– The unit should be situated away from heat sources such as radiators,
heat registers, stoves or other appliances (including amplifiers) that produce
heat.
4.
Power Sources
– The unit should be connected to a power supply only of the
type described in the operating instructions or as marked on the appliance.
5.
Power-Cable Protection
– Power supply cables should be routed so that
they are not likely to be walked on or pinched by items placed upon or against
them. It is always best to have a clear area from where the cable exits the unit
to where it is plugged into an AC socket.
6.
Cleaning
– The unit should be cleaned only as recommended. See the
Maintenance section of this manual for cleaning instructions.
7.
Objects and Liquid Entry
– Care should be taken so that objects do not fall
and liquids are not spilled into any openings or vents located on the product.
8.
Attachments
– Do not use attachments not recommended by the product
manufacturer.
9.
Lightning and Power Surge Protection
– Unplug the unit from the wall
socket and disconnect the antenna or cable system during a lightning storm or
when it is left unattended and unused for long periods of time. This will prevent
damage to the product due to lightning and power-line surges.
10.
Overloading
– Do not overload wall sockets, extension cords, or integral
convenience receptacles as this can result in a risk of fire or electric shock.
11.
Damage Requiring Service
– The unit should be serviced by qualified service
personnel when:
A. the power supply cable or plug has been damaged.
B. objects have fallen into or liquid has been spilled into the enclosure.
C. the unit has been exposed to rain.
D. the unit has been dropped or the enclosure damaged.
E. the unit exhibits a marked change in performance or does not operate
normally.
12.
Periods of Nonuse
– If the unit is to be left unused for an extended period of
time, such as a month or longer, the power cable should be unplugged from
the unit to prevent damage or corrosion.
13.
Servicing
– The user should not attempt to service the unit beyond those
methods described in the user’s operating instructions. Service methods not
covered in the operating instructions should be referred to qualified service
personnel.
Questions? Visit www.ihome.com
or call 1-800-288-2792 Toll Free
• Place the unit on a level surface away from sources of direct sunlight or excessive
heat.
• Protect your furniture when placing your unit on a natural wood and lacquered
finish. A cloth or other protective material should be placed between it and the
furniture.
• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger
cleaning agents, such as Benzene, thinner or similar materials can damage the
surface of the unit.
Maintenance
