8
Using the iD85
Nap Operation
Nap mode lets you set an alarm separate from the Alarm 1 and Alarm 2 settings. The nap wake to source by default is the
buzzer alarm, but if an iPad/iPhone/iPod is docked, that will act as the alarm source. If you are listening to the radio or
aux-in source, it will be muted and the buzzer will sound at the selected wake time.
1. Press the
Nap Button
located on top of the unit as needed to adjust the nap timer for 5, 10, 15, 20, 30, 45, 60, 90 or
120 minutes or OFF.
2. To cancel nap mode, press the
Nap Button
until OFF is displayed. To turn off the nap alarm once it sounds, press the
Button
.
Dimmer Operation
During normal operation (when no alarm is sounding), press the
Snooze/Dimmer Button
to control the brightness of the
LCD display.
Using the iD85 in Other Countries
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that
matches the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you
live in the US, you may skip this section.
1. Make sure the iD85 is OFF (not playing in any mode). Press and hold the
Mode Button
for about 5 seconds until “Radio
xxx” appears in the lower part of display. Press the
+
or
- Button
to set the “xxx” to your region.
2. Press the
Mode Button
again (or no button within 5 seconds) to exit the radio frequency setting mode.
We recommend the use of alkaline batteries for longer life
.
The iD85 comes with 2 AA back-up batteries installed to provide continuous alarm operation
and clock settings in the event of a power failure. When the Battery Low Icon located on the
right of the display is flashing, it is time to replace the back-up batteries.
1. Open the battery compartment cover located on the bottom of the unit.
2. Please make sure the AC adaptor is connected, otherwise all settings may be lost during
battery replacement.
3. Insert 2 AA batteries, checking that the polarity (+ and – ends of the battery) matches the
drawing near the battery compartment. Close the compartment door.
Note:
Make sure you dispose of batteries properly (see your local regulations).
Installing/Replacing Clock Back-up Batteries
Battery Warning
For models that require more than one battery
• Do not mix with used or other battery types/brands
• Replace all batteries at the same time
• Do not open batteries
• Do not dispose of in fire
• Do not heat above 75ºC (167ºF)
• Do not expose contents to water
• Do not charge or recharge
• Do not install backwards
