time set
time set
time zone
dst
+1 -1 auto
volume limit
off on
DC 9V 3A
HWL83
Staff Quick Start Guide
Included
• HWL83 system
• Universal AC adaptor
Set Up
Daylight Saving Time
Press the
time set button
to confirm year. The date will flash.
Press the - or
+ button
to adjust time (hold for rapid adjust).
Make sure to set the correct AM or PM time.
Manual Clock Setting
HWL83QSG-020116-A
© 2016 HTI Industries, LLC. All rights reserved
Printed in China
• Place the unit on a level surface away from sources of direct sunlight or
excessive heat.
• Clean your unit with a soft, damp cloth. Strong cleaning agents, such as
thinner or similar materials can damage the surface of the unit.
Setting the Time Zone and Clock
(Factory Preset Clock)
Press the
time set button
to confirm time. The year will flash.
Press the
-
or
+ button
to set the year.
Press the
-
or
+ button
to set the date (hold for rapid adjust).
Press the
time set button
.
2 beeps will confirm Clock Setting
is complete.
√
Remove thumbscrew and
remove back security cover to
access staff controls (volume
limit switch, DST switch, time
set button, time zone button),
and DC jack.
Connect the universal voltage
AC adapter to the wall outlet
and the DC jack on the back
panel of the unit.
Charging Devices
Connect USB cable (not includ-
ed) to USB port and the other
end to your device to charge.
The unit ships with the
Daylight Saving Time
(DST)
switch
in
Auto position, and will automatically adjust when the time
changes in March and November. To switch manually, slide switch
to +1 to add an hour or to -1 to subtract an hour.
Press and hold the
time set button
on the back of the unit
to enter
clock setting mode. The time will flash and CLOCK SET will appear
on the display.
Once staff has completed
setup, adjust cable on AC
adapter to fit under the cable
housing on the security cover
on back of unit and tighten
thumbscrew.
The first time you connect your new preset clock to the AC outlet,
the unit will automatically show the correct Eastern Standard
time, which is the default setting. If you are not in the Eastern time
zone, you must change the default setting to match your time
zone (see
Time Zone Setting
below). Once the correct time zone is
set, if the time displayed is not correct, follow steps under
Manual
Clock Setting
to set the correct hour, minute, year and date.
Press and release the
–
or
+ button
as needed until your time
zone is displayed. The time display will also change.
When Low Battery Icon flashes on the right of the display,
replace backup batteries with 2 fresh AA batteries. Keep unit
connected to AC power when replacing batteries or you will
lose settings. Make sure to match polarity (+/–) on batteries as
shown below.
Battery Cautions and Tips
• Only use the recommended/supplied batteries or equivalent.
• Use alkaline batteries for longer life.
• Do not mix old and new batteries, and do not mix alkaline, carbon-zinc or rechargeable
nickel-cadmium batteries.
• Insert batteries with proper polarity (+/–) as indicated.
• Remove exhausted batteries from product.
• Do not attempt to recharge non-rechargeable batteries.
• Do not open batteries or heat them beyond normal ambient temperatures.
• To prevent battery leakage or damage remove batteries from a product if it will not be used
for a month or longer.
• Use extreme caution handling leaking batteries (avoid direct contact with eyes and skin). If
battery leakage comes in contact with eyes, IMMEDIATELY flush the eye with lukewarm and
gently flowing water for at least 30 minutes. If skin contact occurs, wash skin with clear
water for at least 15 minutes. Seek medical attention if any symptoms occur.
• Store in cool, dry, ventilated area away from hazardous or combustible material.
• Do not dispose of batteries in the household trash or fire.
• Follow applicable laws and local regulations for the disposal and transportation of batteries.
TIP
: Press the
Alarm On/Off Button
when display
is flashing during clock setting to toggle
between 12 hour and 24 hour display modes.
Time Zone Setting
Battery backup installation
time zone
time zone
time set
time set
time set
Cable on AC adapter
time set
time zone
dst
+1 -1 auto
volume limit
off on
DC 9V 3A
Volume Limiter
The unit ships with the
Volume Limit switch
in OFF position, and
the maximum volume output will be at 100%. For smaller rooms,
slide the switch to the ON position to limit/lower the maximum
volume by 25%.
Note
: Make sure that the Year, Month, and Date settings are correct so
that the Auto Daylight Savings Time adjustments will occur on time.
Press and hold the
time zone button
. The default EASTERN time
zone will flash in the bottom of the display.
Press and release the
time zone button
to confirm time zone
setting.
AA x 2
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device may
not cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
CAN ICES-3 (B)/NMB-3(B)
Secure the attached Security Tether to a wall or other
permanent surface.
CAUTION: DO NOT attach to an AC outlet or cause it to
become entangled with anything that can create a
hazardous situation.
Tips For Guests
time set
time zone
dst
+1 -1 auto
volume limit
off on
DC 9V 3A
outlet
HWL83 Quick Start Guide - Inside
HWL83 Quick Start Guide (English) - Front
Size: 432 x 140 mm
Color: 1C + 1C (Black)
Material: 100 gsm WF paper
Date: Feb 01, 2015
• Using the wireless charger:
Place compatible device with back side down in middle of marked charging target
circle. Check the wireless charging indicator icon on the right of the display:
•
Rapid blinking icon
– Device is not charging. Reposition device.
•
Slow blinking icon
– Device is charging properly.
•
Solid icon
– Device is charged (some devices do not support this feature).
•
No icon
– Not in charging mode (no device on unit)
• Thick device cases can interfere with wireless charging. Removing such a case
may improve wireless charging.
• Wireless charging uses a magnetic field. Avoid placing personal items with
magnetic stripes, such as credit cards, bank cards, key cards, etc., near the
wireless charging area to prevent damage.
Note: This unit is compatible with the Qi wireless charging standard. PMA wireless
charging is not supported.
Folded size: 108x 140(mm)
