Using the
Si-B62
P8
7
Replacing and Installing Clock Backup Batteries
Note: 2 AAA batteries are included with the unit. Install them before using the unit.
This model is equipped with a battery backup circuit that will maintain the time and alarm time settings in the event of
a temporary power interruption (the display is NOT maintained). The battery backup circuit will also operate the
buzzer alarm to wake you up at the selected wake up time even if the power is out. When the backup batteries are
getting weak the Low Backup Battery Indicator will appear solid on the display. When you see this flashing indicator
you should replace the backup batteries as soon as possible. Note: We recommend alkaline batteries for best
performance.
To install/replace the backup batteries
:
IMPORTANT: When replacing the backup batteries be sure to have the unit connected to the AC outlet to maintain all of your
settings, otherwise it will be necessary to reset the time and alarm time after the batteries are replaced.
1. Slide and remove the battery door located on the bottom of the unit.
If replacing batteries, remove the exhausted batteries.
2. Insert 2 fresh AAA batteries in the backup battery compartment.
Make sure the polarity of the batteries (“+” or “-” nodes) matches the
illustration.
3. Slide and close the battery compartment door. Confirm that the
backup battery indicator is not flashing in the display.
Note: Make sure you dispose of batteries properly (see your local
regulations)
Battery Warning
• Do not heat above 75ºC (167ºF)
• Do not expose contents to water
• Do not open batteries
• Do not dispose of in fire
• Do not install backwards
Setting the Clock
1. When unit power off press and hold the
Clock/Presets Button
for 2 seconds until the hour display
flashes and a beep sounds.
2. Press the
–
or
+ Buttons
to adjust the clock to the current hour. Make sure you set the correct AM/PM
time. The PM indicator appears to the left of the display (there is no AM indicator).
3. Press the
Clock/Presets Button
to confirm the hour. The minutes display will flash.
4. Press the
–
or
+ Buttons
to adjust the clock to the current minute setting.
5. Press the
Clock/Presets Button
to confirm the time and exit clock setting mode. 2 beeps will confirm
clock setting is complete.
FM Radio
Extend the FM antenna for best reception.
1. Press and release the
Power/Mode Button
as needed until the FM indicator icon and current FM
radio frequency appear on the display.
2. Press the
–
or
+ Buttons
to tune the radio to the desired station (hold to scan for the next clear station).
3. Press the
or
Buttons
to adjust the volume on the unit.
4. When you are through listening, press and hold the
Power/Mode
Button
to turn the unit off.
Using the
Si-B62
8
P9
