28
29
Q-LOC assembly
1. Check the segmented flange is expanded before installation. Open the lever completely.
2. Slide in the axle until it “clicks”. Make sure the segmented flange is expanded.
3. Set the tension of the nut until the flange is flush with the dropout.
4. Close the lever completely. Check if it’s firmly seated. Re-tighten the nut if necessary.
Q-LOC removal
1. Open the lever completely.
2. Press and turn adjust nut clockwise until segmented flange retracts and stays latched.
3. Pull out the axle.
Axle assembly for front 15mm thru-axle
1. Position your front wheel into the dropouts of the lower fork leg. As you
are installing the front wheel, be sure to squarely position the brake rotor
in between the brake pads of the disc caliper. The hub shoulders should
seat squarely and firmly in the dropout counterbores.
2. Insert the axle into the left side of the fork dropout and slide it all the way
through the hub, until you contact the axle nut on the other side.
3. Thread the axle into the axle nut and push the release lever back to the CLOSE position.
If the release lever can be easily pushed to the CLOSE position,
release the lever and continue to thread the axle nut until maximum
clamping force is achieved by hand when closing the lever.
for : OUTLAND CABOT RS1 | OUTLAND SAWBACK RS1
for : OUTLAND TORNGAT RS1
MECHANICAL COMPONENTS
PUSH
TURN
PUSH
TURN
+
_
PUSH
TURN
