truss or an appropriate fastening point. Hang up the end in the fastening element and tie up the
locking nut. A safety rope once exposed to failing load or damaged may not be used furthermore.
The maximum drop exceed must not exceed 20cm.
A safety rope once exposed to failing load or damaged may not be used furthermore.
Adjust the desired inclination angle via the mounting bracket and tighten the screw.
3. Introduction
Thank you for buying the Pico 2
For a successful installation and operation, please
4. Commissioning
Turn on the device with the power button at the bottom of the device.
Push the ON button on the IR remote control. The unit turns on an
4.1. Charging
Connect the LED headlamp with
you have bought a Tourpack you can connect the device with pre
While charging the LED headlamp should be turned off,
The loading process can take up to
If you turn the switch on the charging rail you can see the
possible with the Tourpack). If you have not bought a T
see the state of charge in a little inspection window at the top of the device.
6 / 12
truss or an appropriate fastening point. Hang up the end in the fastening element and tie up the
locking nut. A safety rope once exposed to failing load or damaged may not be used furthermore.
um drop exceed must not exceed 20cm.
A safety rope once exposed to failing load or damaged may not be used furthermore.
Adjust the desired inclination angle via the mounting bracket and tighten the screw.
2 IR.
It is a powerful device.
and operation, please read this manual carefully.
Turn on the device with the power button at the bottom of the device.
Push the ON button on the IR remote control. The unit turns on and is ready for operation.
the included power supply with the power supply system.
you have bought a Tourpack you can connect the device with pre-installed XLR connectors.
While charging the LED headlamp should be turned off, otherwise there can be no
can take up to 10 hours, depending on the remaining charge
If you turn the switch on the charging rail you can see the state of charge for every battery (only
possible with the Tourpack). If you have not bought a Tourpack switch the power button, then
see the state of charge in a little inspection window at the top of the device.
truss or an appropriate fastening point. Hang up the end in the fastening element and tie up the
locking nut. A safety rope once exposed to failing load or damaged may not be used furthermore.
A safety rope once exposed to failing load or damaged may not be used furthermore.
Adjust the desired inclination angle via the mounting bracket and tighten the screw.
d is ready for operation.
the included power supply with the power supply system. In the event
installed XLR connectors.
there can be no sufficient charge.
charge of the battery.
state of charge for every battery (only
ourpack switch the power button, then you can
