Ignite B6A800101, Руководство по эксплуатации и техническому обслуживанию

Страница: 32 / 44

30
Problem Cause Correction
Drive chain damaged or
broken. Chain connecting link broken. (The chain link is
used as a mechanical fuse and is meant to
break to avoid chain damage or other
component damage.) Replace chain link.
Sprockets out of alignment. Align sprockets.
Loose chain. Tighten chain to correct tension.
Broom bearing damaged, loose bearing
mounting bolts, and / or improper installation of
bearings. Repair or replace.
Abruptly reversing the broom rotation. Allow broom to stop rotating before
changing broom rotation direction.
REMOVING AND INSTALLING THE
BRISTLES
Removing and Installing the Bristles
Figure 45
C209918a
• Remove the two bolts (Item 1) and remove the drive
chain cover (Item 2) [Figure 45].
Figure 46
C209918b
• Remove the three bolts (Item 1) and remove the
rubber shield (Item 2) [Figure 46].
NOTE: For additional chain removal, installation, and
adjustment information,
(See Removing And Installing The Chain on
Page 33) .
PREVENTIVE MAINTENANCE