-10-
www.igmtools.com
Step 30. Take the switch box, open it by removing the bolt at the bottom
of the switch box to mount to the switch base plate using (4) 3/8”*1” hex
bolts, (8) 3/8” flat washers and (4) 3/8” hex nuts.
Step 31. Install the Switch Box to the switch plate on the motor using (4)
1/4” x 3/4” hex bolts, (4) 1/4” x 1” flat washers and (4) 3/8” lock washers.
Step 32. All the assembly steps have been completed.
6. Maintenance procedures
CLEANING THE FILTER
To ensure proper operation of this Mobile Dust Cyclone, the HEPA
canister filter must have adequate air flow. This means the filter must be
regularly maintained by carefully blowing the filter clean using compressed
air and an air gun to release built-up particulates trapped between the
filter pleats.
For heavy duty users, it is recommended to use compressed air on a
regular basis to maintain maximum filtration efficiency and longer life span
of the filter.
Using the Filter Cleaner Crank and Compressed Air
DISCONNECT MACHINE FROM POWER!
The filter cleaner crank knocks dust particulate and small debris from
the pleated filter and into the filter bag. To improve the effectiveness
of the paddles, slowly rotate the handle while simultaneously blowing
(from outside – in) into the pleats. This will assist the release of fine dust
from the inside of the pleats. NOTE: using the blowing function (hose
connected to exhaust port) of a vacuum can also help dislodge dust.
To keep your machine in good working condition, it is recommended to
use the filter cleaner crank to clean the filter after every use.
To clean the filter using the crank simply rotate the crank handle clockwise
four or five rotations.
NOTE: Excessive turning of the filter cleaner crank or fast turning will
prematurely wear the interior of the pleated filter.
REMOVING THE CANISTER FILTER
1. Release the spring-loaded band clamp at the bottom of the canister
filter and remove the plastic debris bag.
2. Remove the bolt and washer from the bottom, center of the flap pivot
assembly using a 12mm wrench.
3. While supporting the canister filter assembly from the bottom, release
the spring-loaded band clamp from the top of the canister filter assembly.
Hold canister from bottom when releasing clamp (top)
Disassembling canister for cleaning
4. Remove the canister filter by carefully lowering the canister. Be careful
to tilt the top of canister, if necessary, to clear the paddle branches.
5. With the canister filter removed use a compressed air gun to thoroughly
clean between the pleats, both inside and outside.
Содержание Laguna CFlux 1
