-3-
www.igmtools.com
Operating Instructions EN
Fig 4
Fig 5
Fig 6
Mount and operate trimmer on worktable
• Mount trimmer on the worktable, and operate with straightline trimming procedure.
• Make sure the trimmer is mounted with adjustable handle, axle.1 and cap.2 stably. Also screw the cap.2 and
cap3 tightly. (Fig 2)
• Make sure the trimmer tightened with screw.1 and trimmer holder can swag, than fasten the cap.A tightly。
• Fasten screw.2 to the side of work table tightly (Fig3).
Fig 1
Fig 2
Fig 3
• Mount and fasten the lead plate on worktable. (Fig 4)
• Adjust the appropriate length for work piece and fasten with adjustable handle. (Fig 5)
• Set the appropriate width for the work piece, and follow the direction shown on (Fig 6)
• Adjust the bearing with router bit lean against work piece. Fasten the adjustable handle and check the trimmer
holder which can swag up and down. After the correction, place movable plate on work table, adjust the
appropriate width and follow the instruction as shown on (Fig6)
Fig4
Fig 5
Fig 6
14
13
4
4
