en
14
User manual WOJTEK
www.igloo.pl
4.1. Temperature regulation
Service of “Igloo” and “Carel” thermostat (temperature regulators) is described in chapter 7 (p.17 and 18)
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device and
maintain it within the determined temperature ranges. The producer enters all settings of temperature regulators required
for normal functioning of the device. Before primary actuation the user should control and possibly set the required tem
-
perature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious consequ
-
ences, including the damage of the cooling device!
When using the display cabinet, as well as during maintenance works, pay attention not to destroy the
temperature sensor in the evaporator screen!
It is recommended to make a break in the exploitation of the device
once a month
in order to clean its interior, naturally
defrost the evaporator, clean the condenser and verify the condition of door seals.
Do not use mechanical agents in order to fasten the defrosting process!
It is essential to keep the
condenser of the device
clean. Dirt may
hinder the heat exchange, causing mainly increase in electric energy
consumption and may cause damage of aggregate compressor.
In order to clean the condenser it is necessary to unscrew the sheet
metal screws and pull the wind brace out. Clean condenser lamellas
with help of soft brush or paintbrush. If the condenser is extremely dirty
(blocked lamellas) it is indicated to use vacuum cleaner or compressed
nitrogen to suck / blow the dirt from between lamellas.
The producer shall not be held responsible for damages of the condenser aggregate resulting from non-
observance of condenser cleanliness!
5. MAINTENANCE
5.1. Cleaning and maintenance
All maintenance services need to be performed after disconnecting the device from power supply!
Protect electric installation against any damage or water spillage
Do not use water stream to clean the device, only a wet cloth
Do not use any sharp objects to remove filth!
Fig.6 Cleaning the condenser
Elements of device can corrode when improper used and maintenance. To avoid that please
follow the rules:
• Do not allow contact of the surface of the device with substances containing chlorine and / or baking
soda in different varieties, which destroy the protective layer and components of the device (also
includes various stainless steel)
During maintenance services it is necessary to pay attention not to damage the data place of the device
Fig.7 (p.15), which contains significant information for servicing organs and waste removal companies.
