Igloo OLA 1400.2 AG, Руководство пользователя

Страница: 15 / 40

en
15
COOLING CABINETS, MEDIUM-FREEZING AND FREEZING CABINETS WITH UPPER AGGREGATE (“AG” TYPE) www.igloo.pl
Remarks and indications
• After transporting the device, wait about 2 hours before its actuation.
• The fi rst fi lling of the freezing space should be performed after its previous cooling to working temperature.
This principle should also be observed after longer pause in exploitation.
• Do not place hot products in cooling and freezing devices.
• It is forbidden to place bottles and cans with drinks in freezing devices. Their content may expand when fro-
zen, rupturing the container. Risk of injuries and damages!
• During the day it is unadvisable to place more products in the chamber of the device than its freezing capacity
can handle.
• In order to ensure proper food storage conditions, it is forbidden to fully complete the shelves.
• In order to prevent freezing of the packages it is essential to dry them before placing them in the device.
• Do not block any ventilation holes, which would hamper the cooled air circulation.
• Keep the condenser clean. Impurities may lead to overheating of the compressor and as a consequence may
result in damage of the device, which is not covered by warranty!
• Do not use electric devices inside grocery product storing chamber
• After closing the doors, do not try to use force to open them. Under pressure created inside the device is
equalled within 1-2 minutes, which enables free opening of the doors.
• Avoid unnecessary opening of the doors and leaving them open for a longer period of time.
4.1. Temperature regulation
“Igloo” and “Carel” thermostat (temperature regulators) service is described in chapter 7 (p. 19 and 20)
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device and
maintain it within the determined temperature ranges. The producer enters all settings of temperature regulators required
for normal functioning of the device. Before primary actuation the user should control and possibly set the required tem-
perature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious consequ-
ences, including the damage of the cooling device!
5. MAINTENANCE
5.1. Cleaning and maintenance
All maintenance services need to be performed after disconnecting the device from power supply!
Protect electric installation against any damage or water spillage
Do not use water stream to clean the device, only a wet cloth
Do not use any sharp objects to remove dirt!
It is recommended to make a break in the exploitation of the device once a month in order to clean its interior,
naturally defrost the evaporator and verify the condition of door seals.
Do not use mechanical agents in order to fasten the defrosting process!