Page
3
of
6
How to use BTR006L
Charge the battery
Fully charge the device before first use. See Battery and Charging Procedure for more details.
1.
Turn on/off the receiver
Function
Operation
LED indicator
Turning on
Press and hold MFB button for 3-5 seconds Blue LED is on for 1 second
Turning off
Press and hold MFB button for 3-5 seconds Red LED is on for 1 second
2.
Pairing
Pairing is the process of establishing an encrypted link between BTR006L and Bluetooth
enabled devices.
How to enter pairing mode on the receiver
Function
Operation
LED indicator
Entering pairing
mode
Ensure the receiver is turned off. Then
press and hold MFB button for 6-7 seconds
until Red and Blue LED light flashes
alternately
Red and Blue LED light
flashes alternately
Notes:
Pairing mode will last for 2 minutes. The receiver will switch automatically to standby mode
if no devices can be connected in this time.
Pairing with a Bluetooth enabled mobile phone/MP3 player/tablet
Step-1
Ensure your Bluetooth enabled device supports A2DP profile. The pairing procedures
will vary depending on your device. Please refer to your device’s user manual for specific
information. The steps below are general pairing procedures.
Step-2
Place the receiver and Bluetooth device close together, ideally no more than 1 metre
apart.
Step-3
Put the receiver into pairing mode (see ‘How to enter pairing mode on the receiver’)
Step-4
Follow the operating instruction of your Bluetooth device to start the pairing process.
Typically, this is done by going to a “Connect” or “Setup” menu and then selecting the option
to search for BTR006L that is still in the pairing mode.
Step-5
The device will find BTR006L and ask whether you are willing to connect your device
with the receiver. Press “Yes” or “Confirm” to confirm this action.
Step-6
Your device’s display might then prompt you for a passkey or PIN. Enter 0000 (a
sequence of four zeros) and the display should prompt the pairing result (Devices with
Bluetooth V2.1 or above should not need to do this).
If the connection is successful, the Blue LED will quickly flash twice every 4 seconds. If the
pairing is unsuccessful, please turn off the receiver and turn it on again. Then, return to
Step-1 and do the pairing procedure again.
Notes:
After successful pairing, the receiver and Bluetooth device will remember each other;
there should be no need to do the pairing procedure again.
Each time the receiver is turned on it will automatically connect to the last connected
device. If you wish to pair it with other devices please turn off the Bluetooth function of
the last connected device and pair the receiver with the new device using the ‘Pairing with
a Bluetooth enabled mobile phone/MP3 player/tablet’ procedure.
When the receiver is turned on and doesn’t connect to any devices, press the MFB button
twice. It will then connect to the last connected device.
