iFog I-180, Руководство пользователя

Страница: 8 / 8

8
1.
While unit is unplugged and cool, unscrew nozzle at very front of unit and clean out debris with
vinegar and a pipe cleaner, making sure that the hole is free of clogs.
2.
Empty all fog fluid from machine. Add cleaning solution to tank. Plug unit in and begin warm up.
3.
Run unit in a well-ventilated area until tank is empty.
4.
Replace nozzle and refill with liquid.
Cleaning your fog machine regularly will help reduce costly parts replacement and repair
charges.
Important
Always monitor tank fluid level as you are fogging. Running a fog machine without fluid can
permanently damage the unit. If you experience low output, pump noise or no output at all, unplug
immediately. Check fluid level, the external fuse, remote connection, and power from the wall. If all of
the above appears to be O.K., plug the unit again. If fog does not come out after pressing the remote
button for 30 seconds, check the tube attached to the tank to make sure there is fluid going through
inside. If you are unable to determine the cause of the problem, do not simply continue pressing the
remote button, as this may damage the machine. Return the machine to your dealer for inspection.
Performance Notes
•
All fog machines develop condensation around the output nozzle. Because this may result in
some moisture accumulation on the surface below the output nozzle, consider this
condensation when installing your machine.
•
Fog machines may sputter small amounts of fog occasionally during operation and for a minute
or so after being turned off.
•
I-180 fog machine has a heating cycle after bursts of fog so the machine stops fogging for a
short period in order to heat up. During this time no fog can be produced.
•
Only use liquids with certified suitability.
Save these instructions