IFM E30430, Руководство по эксплуатации

Страница: 16 / 17

E30430 IO-Link INLINE DISPLAY 1.44"
16
11 Troubleshooting
11.1 Warning messages
Indication Description Type Instruction
1 ERROR Device faulty / malfunction Error
u
Replace device
2 (off) Supply voltage too low Error u Ensure a voltage supply with a sufficiently
available current.
(18…30 V DC)
3 PARA Parameter setting outside the valid
range Error 1. Save the parameter settings
2. Restore the factory settings
3. Enter parameters again
PARA
invalid device cata-
logue, try cata-
logue update
Device catalogue no longer up to date
u Reinstall device catalogue
4 no connection No IO-Link connection between the
master and the device was found Error • If the device is only connected to a power
supply, this status is normal
• If parameter IO-Link = OFF:
u Check the cable connections and the
function of the connected IO-Link
participants
u
If necessary, re-establish the
communication
5 invalid Invalid flag of the process data
(PDV) is set. Indicated in the process
value line. Error The process value of the connected device is
marked as invalid
u
Check the connected device
6 unsupported de-
vice of vendor
<xxx> No process data description for the
device available Error The connected device is not in the device
catalogue
unknown ifm de-
vice try catalogue
update Device catalogue no longer up to date
u
Device catalogue update: device
catalogue download for ifm devices at
www.ifm.com
7 invalid process da-
ta description The process data description does
not match the communication con-
tent Error Process data recognition error
u
Restart the communication with the
connected device, e.g. by disconnecting
and reconnecting the device
8 Loc The setting buttons on the device are
locked, parameter change rejected Warning
u
Unlock device
9 C.Loc Parameter setting via buttons disa-
bled, parameter setting via IO-Link
communication is active Warning
u
Wait until the parameter setting via the
remote participant is finished
10 S.Loc Setting buttons locked via parameter
setting software, parameter change
rejected Warning
u
Unlock the setting buttons via the
parameter setting software
11 no process data
available No process data is available Warning The device is in the pre-operate mode
u Wait until the connection is established