Operating instructions AX460
24
LINEARIZATION
This parameter defines the linearization function
� The linearization points are set in the IN 1 / IN 2
LINEARIZATION menu�
OFF
No linearization
1 QUADRANT
Linearization in the 1st quadrant
4 QUADRANT
Linearization in all 4 quadrants
TOTALIZATION
This parameter activates the totalization function� Settings are made in the IN 1 / IN 2 TOTALIZATION
menu� The totalization depends on the selected operating mode
�
NO
No totalization
YES
Totalization active
9.4 IN 1 Linearization
In this menu, the linearization points for input 1 are defined� This menu is only
displayed if the corresponding linearization is selected in the IN 1 PROPERTIES
P1(X) ... P24(X)
X coordinate of the linearization point
This is the display value which the device generates without linearization depending on the input signal�
-99999999
Lowest value
0
Default value
+99999999
Highest value
P1(Y) ... P24(Y)
Y coordinate of the linearization point
This is the display value which the device is to generate instead of the X coordinate� For example, P2(X) is
replaced by P2(Y)�
-99999999
Lowest value
0
Default value
+99999999
Highest value
9.5 IN 1 Totalization
In this menu the parameters for the totalization are defined� This menu is only
displayed if the totalization has been activated in the IN 1 PROPERTIES menu�
The totalizer depends on the selected operating mode (see table below)�
Operating mode
Totalizer
INPUT 1 TOTAL
INPUT 2 TOTAL
LINKAGE TOTAL
SINGLE
active
→ 0
→ 0
DUAL
active
active
→ 0
